Siemens SINUMERIK 802D sl Programming And Operating Manual page 346

Appendix
A.2 Parameter tables of the tool data
In addition to the default coding of the tool data (tool type, cutting edge position, etc.), the
following coded parameters are used.
Encoding
0
1
2
3
4
5
Encoding
0
1
2
11
12
21
22
Encoding
0
1
...
11
12
21
346
Wheel type $TC_TPC1[T]
free contour
Standard contour straight without rear definitions
Standard contour straight with rear definitions
Standard contour inclined left
Standard contour inclined right
Standard contour straight profile roller with geo axes
Dressing mode at the diameter $TC_DP19[T,1]
neither drawing nor plunging (3rd dresser)
drawing (last active dresser)
plunging (last active dresser)
drawing (1st dresser)
plunging (1st dresser)
drawing (2nd dresser)
plunging (2nd dresser)
Dresser type $TC_DPC6[T,_GC_DNUM+dresser-1]
Dresser geometry axes (diamond) non-rotating
Dresser geometry axes (diamond) non-rotating
Dresser, geometry axes (form roll) rotating
Dresser, geometry axes (form roll) rotating
Dresser, geometry axes (diamond) rotating
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding