Program Setting Data - Siemens SINUMERIK 802D sl Programming And Operating Manual

4.7

Program setting data

Functionality
The setting data are used to define the settings for the operating states. These can be
changed as necessary.
Operating sequence
You are now in the <OFFSET PARAM> operating area.
Press the "Setting data" softkey. The start screen "Setting data" is opened. Other softkey
functions are available here with which you can set various control system options.
Figure 4-23
● JOG feedrate
● Spindle
● Minimum / maximum
● Limitation using G96
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Setting data start screen
Feedrate value in JOG mode
If the feedrate value is zero, the control system will use the value stored in the machine
data.
Spindle speed
A limitation of the spindle speed in the "Max." (G26) / "Min." (G25) fields can only be
performed within the limit values defined in the machine data.
Programmable upper speed limitation (LIMS) at constant cutting rate (G96).
Setup
4.7 Program setting data
49