Error Messages And Error Handling; General Information; Error Handling Within Cycles - Siemens SINUMERIK 802D sl Programming And Operating Manual

9.3.2

Error messages and error handling

9.3.2.1

General information

If error conditions are detected in the cycles, an alarm is generated and the execution of the
cycle is aborted.
The cycles continue to output messages in the dialog line of the control. These message will
not interrupt the program execution.
Reference
For more information on errors and required responses, as well as messages output in the
controller's dialog line, please refer to the SINUMERIK 802D sl Diagnostics Manual.
9.3.2.2

Error handling within cycles

Alarms with numbers between 61000 and 62999 generated in the cycles. This range of
numbers, in turn, is divided again with regard to alarm responses and cancel criteria. The
error text that is displayed together with the alarm number gives you more detailed
information on the error cause.
Alarm number
61000 ... 61999
62000 ... 62999
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Clearing Alarm Response
criterion
NC_RESET Block preparation in the NC is aborted
Clear key Program execution is not interrupted; display only
Cycles
9.3 Programming cycles
159