Note
Using the softkey function "Continue...", you may also inspect the transmission log. The
"Error log" function is available for that.
Use this function to display and change the RS232 interface parameters. Any changes in the
settings come into effect immediately.
Selecting the "Save" softkey will save the selected settings even beyond switching off.
The "Default settings" softkey will reset all settings to their default settings.
Figure 8-44
Interface parameters
Table 8- 8
Parameter
Device type
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Parameters of the RS232 interface
Interface parameters
Description
RTS CTS
The signal RTS (Request to Send) controls the send mode of the data transfer
device.
The CTS signal indicates the readiness to transmit data as the acknowledgment
signal for RTS.
8.6 SYSTEM - "Start-up files" softkeys
System
149