Siemens SINUMERIK 802D sl Programming And Operating Manual page 94

Part programming
7.4 Free contour programming
Figure 7-6
Initially, you define a contour start point (see Chapter "Defining a start point (Page 97)").
The contour is then programmed step-by-step (see chapter "Programming example, surface
grinding (Page 105)").
Figure 7-7
Softkeys for the contour elements
The following are contour elements:
● Start point
● Straight line in the vertical direction (transverse)
94
Define a start point
Edit contour elements
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding