6.8
Repositioning after interruption
After interrupting the program (<NC STOP>), you can retract the tool from the contour in
manual mode (JOG). The control saves the coordinates of the point of interruption. The
distances traversed are displayed.
Operating sequence
Select <AUTOMATIC> mode.
Press <NC START> to continue machining.
When reapproaching the interruption point, all axes will traverse at the same time. Make
sure that the traversing area is not obstructed.
6.9
Execute from external
Functionality
In <AUTOMATIC> mode > <PROGRAM MANAGER> operating area, the following
interfaces are available for external execution of programs:
Customer CompactFlash card
RCS connection for external execution via network (only for SINUMERIK 802D sl pro)
Manufacturer's drive
USB FlashDrive
Surface grinding
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
CAUTION
Automatic mode
6.8 Repositioning after interruption
81