Programmable Mirroring: Mirror, Amirror - Siemens SINUMERIK 802D sl Programming And Operating Manual

Surface grinding
Hide thumbs Also See for SINUMERIK 802D sl:
Table of Contents

Advertisement

Programming
10.2 Positional data
Programming example
N10 G17
N20 L10
N30 SCALE X2 Y2
N40 L10
N50 ATRANS X2.5 Y18
N60 L10
Subroutine call - see Section "Subroutine technique "
10.2.9

Programmable mirroring: MIRROR, AMIRROR

Functionality
MIRROR and AMIRROR can be used to mirror workpiece shapes on coordinate axes. All
traversing motions of axes for which mirroring is programmed are reversed in their direction.
Programming
MIRROR X0 Y0 Z0
AMIRROR X0 Y0 Z0
MIRROR
The instructions that contain MIRROR or AMIRROR each require a separate block. The axis
value has no influence. A value, however, must be specified.
Note
Any active tool radius compensation (G41/G42) is reversed automatically when mirroring.
The direction of rotation of the circle G2/G3 is also reversed automatically when mirroring.
220
; X/Y plane
; Programmed contour original
; Contour in X and Z enlarged two times
; Values are also scaled!
; Contour enlarged and offset
; Programmable mirroring, clears old instructions for offset,
rotation, scaling factor, mirroring
; Programmable mirroring, additive to existing instructions
; Without values: clears old instructions for offset, rotation,
scaling factor, mirroring
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding

Advertisement

Table of Contents
loading

Table of Contents