Importing Tool Data - Siemens SINUMERIK 840D sl Commissioning Manual

11/2006
8.9

Importing tool data

Table 8-8 Variable assignment
Variable
$TC_TP1[x]
$TC_TP2[x]
$TC_TP3[x]
$TC_TP4[x]
$TC_TP5[x]
$TC_TP6[x]
$TC_TP7[x]
$TC_TP8[x]
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D sl Commissioning Manual CNC: ShopTurn – 11/2006 Edition
Tool data that has been defined on an external tool presetting device can be
imported directly into ShopTurn tool management.
Save the tool data as an INI file.
The header in the file must be exactly as follows:
;TOOL MAGAZIN ZEROPOINT,TOOL=2,MAGAZIN=0,NPV=0,BNPV=0
However, you can modify the values for "Tool" and "Magazine".
Tool=1: Delete all existing tools in tool management
and replace with new tools.
Tool=2: Add new tools to tool management
Magazine=0: Do not evaluate magazine location number ($TC_MPP6)
Magazine=1: Evaluate magazine location number ($TC_MPP6)
Note
Always keep to the precise order (including blanks) in the header. If you enter
an incorrect header line, the INI file on opening will be evaluated as a G code
program. Starting the program with "Cycle start" causes existing data in tool
management to be overwritten by the data contained in the program.
The tool data must be assigned the following variables in the INI file, where:
x = Tool number
y = Cutting edge number
Description
Duplo number
Tool name
Number of adjacent half locations on
the left to be blocked for oversized
tools.
Number of adjacent half locations on
the right to be blocked for oversized
tools.
Number of adjacent half locations
above to be blocked for oversized
tools.
Number of adjacent half locations be-
low to be blocked for oversized tools.
Magazine location type
Tool status
8 Tool Management
8.9 Importing tool data
Value
Number
Name
ShopTurn default setting
1 = Do not block adjacent location
or
2 = Block half of adjacent location on the left
ShopTurn default setting
1 = Do not block adjacent location
or
2 = Block half of adjacent location on the right
ShopTurn default setting
1 = Do not block adjacent location
ShopTurn default setting
1 = Do not block adjacent location
Number
Bit 1 = 1: Tool enabled
Bit 2 = 1: Tool disabled
Bit 4 = 1: Prewarning limit reached
8-123