Z Positioning With Grinding Wheel - Cycle406 - Siemens SINUMERIK 802D sl Programming And Operating Manual

Cycles

9.5 Z positioning with grinding wheel - CYCLE406

To add a cycle call to the program, carry out the following steps one after the other:
● From the horizontal softkey bar, selection bars for the individual cycles can be selected
● To select a cycle, keep using the vertical softkey bar until the appropriate input screen
● Number values can be directly entered. Entered values are verified for proper range.
● Some parameters that may have only a few values are selected using the toggle key.
● Press <OK> to complete your input (or <Abort> in case of error).
Recompiling
Recompiling of program codes serves to make modifications to an existing program using
the cycle support.
Position the cursor on the line to be modified and select the <Recompile> softkey. This will
reopen the corresponding input screen from which the program piece has been created, and
you can modify and accept the values.
9.5 Z positioning with grinding wheel - CYCLE406
Programming
CYCLE406 (N_SITZ, CLEAR, CAL, Z_LPOS, MODE, Y_POS, Z_POS, ZSTW, A_Z, F_LU,
F_SR, N_FR, FX, XSTART, XENDE)
Parameter
Table 9- 1
Parameter
N_SITZ
CLEAR
CAL
Z_LPOS
164
using the <Grinding cycles> softkey.
plus help display appears on the screen.
Parameter CYCLE406
Data type Meaning
INT
INT
INT
INT
Seat number
Deletes the old offset prior to the approach
Sets axis to Z position at end
Retraction direction
Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
Surface grinding