Clear The Unprot-Xcmtx Alarm; Unqual-Ppm; Clear The Unqual-Ppm Condition; Unrouteable-Ip - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.193 UNQUAL-PPM

The Unprotected Cross-Connection Matrix Equipment alarm indicates that only one functional SSXC
card on the node supports the cross-connection. The alarm clears if the redundant SSXC card is installed.
This alarm could be accompanied by the
on page 2-73

Clear the UNPROT-XCMTX Alarm

If there is no protect SSXC card installed, install one.
Step 1
Allow the newly installed SSXC card to boot.
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 2
for more information or call Cisco TAC (1 800 553-2447).
2.6.193 UNQUAL-PPM
The Unqualified PPM Inserted condition occurs when a PPM with a nonqualified product ID is plugged
into the card's port; that is, the PPM passes the security code check as a Cisco PPM but is not qualified
for use on the particular card.

Clear the UNQUAL-PPM Condition

Obtain the correct Cisco PPM and replace the existing PPM with the new one.
Step 1
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).

2.6.194 UNROUTEABLE-IP

The UNROUTEABLE-IP is not used in this platform in this release. It is reserved for development.

2.6.195 UPGRADE

The System Upgrade in Progress condition indicates that a system upgrade is occurring on the TSC card.
When software is downloaded, it is loaded into the available code volume on the active TSC card. The
software is copied to the available code volume on the standby TSC card next. The
condition on page 2-110
occurs.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-118
Logical Object: NE
or the "EQPT (EQPT)" alarm on page
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SDH Logical Objects: PPM
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: NE
occurs at that time. When the user activates the load, the UPGRADE condition
"IMPROPRMVL (EQPT for the SSXC or TSC Card)" alarm
2-44.
Chapter 2 Alarm Troubleshooting
"SFTWDOWN"
July 2010