Cisco ONS 15600 SDH Troubleshooting Manual page 260

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2004 No Cisco IOS slot was selected.
EID-2005 CTC cannot find the online help files for {0}.
The files might have been moved, deleted, or not installed.
To install online help, run the setup program on the software or
documentation CDs.
EID-2006 An error occurred while editing the circuit(s).
{0}
{1}.
EID-2007 The preferences could not be saved.
EID-2008 The circuit preferences could not be saved:
{0}
EID-2009 CTC was unable to download the package:
{0}
EID-2010 An error occurred while deleting the destination.
EID-2011 The circuit could not be destroyed.
EID-2012 The reverse circuit could not be destroyed.
EID-2013 The circuit creation failed.
The circuit creation cannot proceed due to changes in the
network which affected the circuit(s) being created.
The dialog box will close. Please try again.
EID-2014 No circuit(s) were selected.
{0}
EID-2015 The circuit {0} cannot be deleted because it has one or more
rolls.
EID-2016 The circuit deletion failed.
EID-2017 An error occurred while mapping the circuit.
{0}
EID-2018 The circuit roll failed.
The circuit must be in the DISCOVERED state in order to
perform a roll.
EID-2019 The circuit roll failed.
Bridge and roll is not supported on DWDM circuits.
EID-2020 The circuit roll failed.
The two circuits must have the same direction.
EID-2021 The circuit roll failed.
The two circuits must have the same size.
EID-2022 The circuit roll failed.
A maximum of two circuits can be selected for a bridge and roll
operation.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-4
Chapter 4 Error Messages
Description
You did not select a Cisco IOS slot.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
An error occurred when CTC tried to open
the circuit for editing.
CTC cannot save the preferences.
CTC cannot find the file needed to save the
circuit preferences.
Refer to the error message text.
CTC could not delete the destination.
CTC could not destroy the circuit.
CTC could not reverse the circuit destroy.
Refer to the error message text.
You must select a circuit to complete this
function.
You must delete the rolls in the circuit
before deleting the circuit itself.
CTC could not delete the tunnel as there are
circuits that use the tunnel.
There was an error mapping the circuit.
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
July 2010