Cisco ONS 15600 SDH Troubleshooting Manual page 284

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3303 The DCC area ID and {0} conflict.
{1}
EID-3304 The DCC number is out of range.
EID-3305 OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface.
EID-3306 Ethernet circuits must be bidirectional.
EID-3307 An error occurred while creating a connection object at {0}.
EID-3308 DWDM links can be used only for optical channel circuits.
EID-3309 The link was excluded because it was in the wrong direction.
EID-3310 The DWDM link does not have wavelengths available.
EID-3311 The laser is already on.
EID-3312 The power setpoint cannot be changed.
{0} {1}
EID-3313 The offset cannot be modified because the service state of the
port is IS.
EID-3314 The requested action is not allowed.
The state value is invalid.
EID-3315 This operation cannot be performed.
EID-3316 The node side is invalid.
EID-3317 The ring name is too long.
EID-3318 The ring name is invalid.
EID-3319 The wrong line was selected.
EID-3320 The optical link could not be deleted.
EID-3321 This feature is unsupported by this version of software.
EID-3322 The equipment is not plugged in.
EID-3323 The APC system is busy.
EID-3324 There is no path to regulate.
EID-3325 The requested action is not allowed.
EID-3326 The input was invalid.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-28
Chapter 4 Error Messages
Description
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
Enter a DCC number that is within the
range.
You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
Refer to the error message text.
CTC encountered an error at the specified
connection while creating the connection.
Refer to the error message text.
The optical channel (circuit) does not allow
the specified link to be included because it
is in the wrong optical direction.
Refer to the error message text.
Refer to the error message text.
CTC cannot change change the power
setpoint. The new setpoint would either
make the thresholds inconsistent or set the
fail threshold outside the range.
Refer to the error message text.
Refer to the error message text.
CTC is unable to perform operation.
This task was applied to the wrong node
side.
Reduce the number of charcters in the
name.
The name you entered is illegal.
Select another line.
CTC cannot delete the optical link.
Refer to the error message text.
Plug in the equipment and proceed.
Automatic power control (APC) system is
busy.
There is no circuit path to regulate.
Generic DWDM provisioning failure
message.
The input value is incorrect.
July 2010