Eqpt-Boot; Clear The Eqpt-Boot Alarm; Eqpt-Cc-Pim; Clear The Eqpt-Cc-Pim Alarm - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.47 EQPT-BOOT

If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 3
for more information or call Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.
2.6.47 EQPT-BOOT
An Equipment Boot Failure alarm occurs when a TSC card, SSXC card, or traffic (STM-N) card does
not fully boot from the restart point after self-rebooting three times.

Clear the EQPT-BOOT Alarm

Complete the
Step 1
Step 2 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.

2.6.48 EQPT-CC-PIM

The EQPT Alarm on a Carrier or 4PIO (PIM) is raised when an LOF or LOS alarm is shown on an ASAP
card but this alarm is not also shown against the 4PIO (PIM) that carries the affected traffic. If multiple
four-port 4PIOs (PIMs) do not show this LOF or LOS alarm, the EQPT-CC-PIM alarm raises against the
ASAP carrier card itself.

Clear the EQPT-CC-PIM Alarm

Complete the
Step 1
If the alarm does not clear, move traffic off any active 4PIOs (PIMs). Procedures and guidelines to do
Step 2
this are located in the "Maintain the Node" chapter in the Cisco ONS 15600 SDH Procedure Guide. Then
complete the
(PIMs) by completing the
information about removing or installing these modules, refer to the "Install Cards and Fiber-Optic
Cable" chapter in the Cisco ONS 15600 SDH Procedure Guide.
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 3
for more information or call Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-46
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
"Clear the EQPT Alarm" procedure on page
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: PIM
"Replace an ASAP 4PIO (PIM) Module" procedure on page
"Replace an ASAP Carrier Module" procedure on page 2-137
"Replace an ASAP 4PIO (PIM) Module" procedure on page
Chapter 2 Alarm Troubleshooting
2-44.
2-138.
and reinstall the 4PIOs
2-138. For more
July 2010