Cisco ONS 15600 SDH Troubleshooting Manual page 270

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2208 This is an invalid or unsupported JRE.
EID-2209 The user name must be at least {0} characters long.
EID-2210 No package name was selected.
EID-2211 No node was selected for upgrade.
EID-2212 A protected line is not provisionable.
WID-2213 The current type or state of some drops does not allow the new
circuit state of {0} to be applied to them indirectly.
EID-2214 The node is disconnected. Please wait until the node
reconnects.
EID-2215 An error occurred while leaving the {0} page.
EID-2216 An error occurred while entering the {0} page.
EID-2217 Some conditions could not be retrieved from the network view Refer to the error message text.
EID-2218 The bandwidth must be between {0} and {1} percent.
EID-2219 The protection operation failed. An XC loopback was applied
on the cross-connection.
EID-2220 The tunnel status is PARTIAL. CTC is not able to change it.
Please try again later.
EID-2221 A valid route cannot be found for the unprotected to {0}
upgrade request.
EID-2222 One or more of the following nodes are currently part of a
four-fiber {0}. Only a single four-fiber {0} is supported per
node.
{1}
EID-2223 Only one circuit can be upgraded at a time.
EID-2224 This link may not be included because it terminates on the
source.
EID-2225 A valid signal could not be detected while trying to complete
the roll.
{0}
EID-2226 The circuit roll failed.
{0}
EID-2320 This VCAT circuit does not support deletion of its member
circuits.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-14
Chapter 4 Error Messages
Description
The version of Java Runtime Environment
(JRE) is either invalid or unsupported.
The user name must be at least of the
specified character length.
You must select a package name.
You must select a node for the upgrade.
The protected line cannot be provisioned.
Choose another line.
The circuit state, specified by {0} cannot be
applied to the selected drops.
Refer to the error message text.
There was an error while leaving the
specified page.
There was an error while entering the
specified page.
The bandwidth must be within the specified
parameters.
As the protection operation failed, a
cross-connect (XC) loopback will be
applied on cross-connection.
Refer to the error message text.
Refer to the error message text.
The nodes, specified by {1}, are already
part of a 4-fiber MS-SPRing type (specified
by {0}).
Refer to the error message text.
Refer to the error message text.
Roll can be completed only when a valid
signal is detected. If not, the roll completion
may result in an error.
Refer to the error message text.
You can not delete a circuit that is a member
of VCAT circuit.
July 2010