Cisco ONS 15600 SDH Troubleshooting Manual page 295

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
WID-6011 Ingress idle filtering should be turned off only when required to
operate with non-Cisco Fibre Channel/FICON-over-SONET
equipment.
EID-6012 The retiming configuration could not be changed because there
are circuits on this port.
EID-6013 The NTP/SNTP server could not be changed.
{1}
EID-6014 The operation failed because the reference state is OOS.
EID-6015 The distance extension cannot be disabled if the port media type
is FICON 1Gbps ISL or FICON 2Gbps ISL.
EID-6016 The card mode cannot be changed to Fibre Channel Line Rate
if the port media type is FICON 1Gbps ISL or FICON 2Gbps
ISL.
EID-6017 The destination of a {0} route cannot be a node IP address.
EID-6018 The destination of a {0} route cannot be the same as the subnet
used by the node.
EID-6019 The destination of a static route cannot be 255.255.255.255
EID-6020 The destination of a static route cannot be the loopback network
(127.0.0.0/8).
EID-6021 The subnet mask length for a non default route must be between
8 and 32.
EID-6022 The subnet mask length for a default route must be 0.
EID-6023 The destination of a {0} route cannot be an internal
network{1}.
EID-6024 The destination of a {0} route cannot be a class D (224.0.0.0/4)
or class E (240.0.0.0/4) address.
EID-6025 The destination of a {0} route cannot be a class A broadcast
address (x.255.255.255/8).
EID-6026 The destination of a {0} route cannot be a class B broadcast
address (x.x.255.255/16).
EID-6027 The destination of a {0} route cannot be a class C broadcast
address (x.x.x.255/24).
EID-6028 The destination of a {0} route cannot be the subnet broadcast
address associated with a node IP address.
July 2010
Description
Refer to the warning message text.
You cannot change the timing configuration
on this port unless the circuits on this port
are deleted.
Refer to the error message text.
Change the Unlocked state to Active.
Refer to the error message text.
Refer to the error message text.
A node IP address cannot be the destination
for a static route.
Refer to the error message text.
The network address such as
255.255.255.255 is not valid. Enter a valid
address.
Refer to the error message text.
Length of subnet mask must be within the
specified range.
Refer to the error message text.
The destination of a static route must not be
an internal network.
The destination of a static route must not be
a Class D or Class E address.
The destination of a static route must not be
a Class A broadcast address. It should be
(xxx.0.0.0).
The destination of a static route must not be
a Class B broadcast address.
The destination of a static route must not be
a Class C broadcast address.
The destination of a static route must not be
a subnet broadcast address of a node IP.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-39