Cisco ONS 15600 SDH Troubleshooting Manual page 275

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3088 No {0} card is present to switch.
EID-3089 The {0} state cannot be used or changed when the {1} has
failed or is missing.
EID-3090 The operation cannot be performed because the {0} is
{1}LOCKED_ON/LOCKED_OUT.
EID-3091 The operation cannot be performed because the protect card is
active.
EID-3092 The requested action cannot be applied because the service
state is invalid.
EID-3093 The operation cannot be performed because the duplex pair is
{0}locked.
EID-3094 The operation cannot be performed because no cross-connect
redundancy is available.
EID-3095 The deletion failed because the circuit is in use
WID-3096 An internal communication error was encountered while
retrieving laser parameters.
This can happen when equipment is not present or when
equipment is resetting.
Check the equipment state and try to refresh the values again.
EID-3097 The ring termination is in use.
EID-3098 No ring terminations were selected.
EID-3099 The entered key does not match the existing authentication key. Check the authentication key and reenter.
EID-3100 An error occurred during authentication.
EID-3101 The DCC metric must be between 1 and 65535.
EID-3102 The DCC metric is invalid.
EID-3103 The IP address {0} is invalid}.
EID-3104 The router priority must be between 0 and 255.
EID-3105 The router priority is invalid.
EID-3106 The hello interval must be between 1 and 65535.
EID-3107 The hello interval is invalid.
EID-3109 The dead interval must be between 1 and 2147483647.
EID-3110 The dead interval must be larger than the hello interval.
July 2010
Description
No card of the specified type is available to
switch.
You cannot use or change the specified state
when the card is failed or missing.
You cannot perform operation.
Refer to the error message text.
Select another service state and proceed.
Refer to the error message text.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
Refer to the error message text.
Refer to the warning message text.
The ring termination you are trying to
access is in use. Try after sometime.
Select one of the ring terminations.
There was an error in authentication. Verify
that the key does not exceed the character
limit .
The DCC metric should be in the range of 1
to 65535.
There was an invalid DCC metric.
The IP address is invalid.
The router priority should be in the range of
0 to 255.
The router priority is invalid.
The hello interval should be in the range of
1 to 65535.
The hello interval is invalid.
The dead interval value must be between 1
and 2147483647.
Refer to the error message text.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-19