Cisco ONS 15600 SDH Troubleshooting Manual page 271

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2321 An error occurred while deleting member circuits.
{0}
WID-2322 Not all cross-connects from selected circuits could be merged
into the current circuit. They might appear as partial circuits.
EID-2323 The circuit roll failed.
Bridge and roll is not supported on monitor circuits.
EID-2324 An error occurred during the circuit upgrade.
{0}
EID-2325 You have failed {0} times to unlock this session. CTC will exit
after you click OK or close this dialog box.
WID-2326 urrently, CTC does not support bridge and roll on circuits that
are entirely created by TL1. To continue with bridge and roll in
CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
WID-2327 Currently, CTC does not support bridge and roll on circuits that
are partially created by TL1. To continue with bridge and roll
in CTC, the selected circuits must be upgraded.
Is it OK to upgrade the selected circuits and continue the bridge
and roll operation?
EID-2328 An error occurred during the circuit reconfiguration.
{0}
EID-2329 {0} of {1} circuits could not be successfully created.
EID-2330 An error occurred during circuit verification. The selected {0}
is invalid!
{1}
EID-2331 Deleting {0} might be service affecting.
EID-2332 A validation error occurred in row {0}.
{1} hold-off timer for {2} must be between {3}-10,000 ms, in
steps of 100 ms.
EID-3001 An Ethernet RMON threshold with the same parameters
already exists. Please change one or more of the parameters and
try again.
EID-3002 An error occurred while retrieving defaults from the node: {0} There was an error while retrieving the
EID-3003 The file {0} cannot be loaded.
EID-3004 Properties cannot be loaded from the node.
EID-3005 NE update properties cannot be saved to the file {0}.
EID-3006 NE update properties cannot be loaded from the node.
July 2010
Description
Refer to the error message text.
Refer to the warning message text.
A monitor circuit does not support Bridge
and Roll.
Refer to the error message text.
The maximum amount of attempts to
unlock this session has been reached.
Refer to the warning message text.
Refer to the warning message text.
The attempt to reconfigure the specified
circuit has failed.
A few circuits could not be created.
The selected item, specified by {0}, is
invalid as per the details, specified in {1}.
Deleting the item can affect the service of
CTC.
Refer to the error message text.
Change a few parameters in an Ethernet
remote monitoring (RMON) threshold and
try again.
defaults from the specified node.
CTC cannot load the specified file.
Refer to the error message text.
CTC cannot save the network element (NE)
update values to the specified file.
Refer to the error message text.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-15