Cisco ONS 15600 SDH Troubleshooting Manual page 262

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-2042 This span is not selectable. Only the green spans with an arrow
may be selected.
EID-2043 This node is not selectable. Only the source node and nodes
attached to included spans (blue) are selectable. Selecting a
selectable node will enable its available outgoing spans.
EID-2044 This link may not be included in the required list. Constraints
only apply to the primary path. Each node may have a
maximum of one incoming signal and one outgoing link.
EID-2045 This link may not be included in the required list. Only one
outgoing link may be included for each node.
EID-2047 Please enter a valid value for the slot number.
EID-2048 Please enter a valid value for the port number.
EID-2050 The new circuit could not be destroyed.
EID-2051 The circuit cannot be downgraded.
{0}
EID-2052 An error occurred during circuit processing.
EID-2054 An error occurred while selecting an endpoint.
EID-2055 No endpoints are available for this selection. Please make
another selection.
EID-2056 A communication error occurred: {0}
EID-2059 An error occurred while deleting the node.
{0}
EID-2060 No PCA circuits were found.
EID-2061 An error occurred while provisioning the VLAN.
EID-2062 An error occurred while deleting VLANs.
No VLAN(s) were selected.
Please select a VLAN.
EID-2063 The default VLAN cannot be deleted.
EID-2064 An error occurred while deleting VLANs.
{0}
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-6
Chapter 4 Error Messages
Description
Refer to the error message text.
Refer to the error message text.
You must select only one link going in and
out of a node. Selecting more than one link
is contradictory to the path selection
algorithm.
Refer to the error message text.
There was an error due to an invalid slot
number.
There was an error due to an invalid port
number.
CTC could not destroy the new circuit.
The specified circuit cannot be
downgraded.
There was an error during the circuit
processing.
There was an error during the endpoint
selection.
This error occurs in the circuit creation
dialog only during a race condition that has
incorrectly allowed entities without
endpoints to be displayed in the
combination boxes.
An internal error occurred in Network
Alarm tab while synchronizing alarms with
the nodes.
There was an error during the node deletion.
CTC could not find any protection channel
access (PCA) circuits for this task.
There was an error defining the VLAN.
Refer to the error message text.
The selected VLAN is the default VLAN
and cannot be deleted.
There was an error deleting the specified
VLAN.
July 2010