Cisco ONS 15600 SDH Troubleshooting Manual page 277

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3132 An error occurred while setting the OSPF area range: {0}, {1},
false.
EID-3133 The maximum number of OSPF area ranges has been exceeded. OSPF area ranges exceeded the maximum
EID-3134 The area ID is invalid. Use the DCC OSPF area ID, LAN port
area ID, or 0.0.0.0.
EID-3135 The mask is invalid.
EID-3136 The range address is invalid.
EID-3137 Your request has been denied because the timing source
information was updated while your changes were still
pending. Please retry.
EID-3138 The clock source for switching is invalid.
EID-3139 A switch cannot be made to a reference of inferior quality.
EID-3140 A higher priority switch is already active.
EID-3141 An attempt was made to access a bad reference.
EID-3142 No switch is active.
EID-3143 An error occurred while creating the static route entry.
EID-3144 The maximum number of static routes has been exceeded.
EID-3145 The RIP metric must be between 1 and 15.
EID-3146 The RIP metric is invalid.
EID-3147 An error occurred while creating the summary address.
EID-3148 No Layer 2 domain has been provisioned.
EID-3149 The MAC addresses could not be retrieved.
EID-3150 The target file {0} is not a normal file.
EID-3151 The target file {0} is not writable.
EID-3152 An error occurred while creating the protection group.
EID-3153 The card cannot be deleted because it is in use.
EID-3154 An error occurred while provisioning the card:
CTC cannot {0} the card.
July 2010
Description
CTC encountered an error while setting the
area range for the specified values.
number.
Refer to the error message text.
Refer to the error message text.
The range address is invalid. Try again.
Refer to the error message text.
You have selected an invalid clock source.
Choose another clock.
Refer to the error message text.
You cannot switch the timing source
manually when a higher priority switch is
already active.
Refer to the error message text.
None of the switches are active.
CTC encountered an error while a creating
static route entry.
The number of static routes has exceeded its
limit.
The Routing Information Protocol (RIP)
metric should be in the range of 1 to 15.
Refer to the error message text.
There was an error while creating the
summary address.
You must provision any one of the Layer 2
domain.
Refer to the error message text.
The specified target file is not a normal file.
The target file is not writeable. Specify
another file.
CTC encountered an error creating
Protection Group.
Refer to the error message text.
CTC cannot perform the task on the card.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-21