Cisco ONS 15600 SDH Troubleshooting Manual page 304

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6248 The cost must between 1 and 15.
EID-6249 The port has a cross-connect.
EID-6250 The reversion time is invalid.
EID-6251 Invalid Margin For Span Aging.
Value is not in the range 0 - 10.
EID-6252 The data cannot be retrieved because ANS parameters cannot
be calculated on the node in its current configuration.
EID-6253 Invalid Margin For Span Aging.
EID-6254 SDH mode does not support timing references.
EID-6255 Only DS1 interfaces with ESF line types support timing
references.
EID-6256 sendDoNotUse and sendDoNotUseFF are mutually exclusive.
EID-6257 The termination is already in use.
EID-6258 The side is carrying services or traffic.
EID-6259 A pluggable module on Port 22 remains unmanaged.
EID-6260 You cannot delete this port.
There was a severe architectural error related to the index of the
pluggable trunk port object.
Please contact technical support for assistance.
EID-6261 This is not a valid VLAN ID. The VLAN database is empty.
EID-6263 The equipment requires two slots.
EID-6264 The patchcord is duplicated.
EID-6265 The wavelength is in use by an OCH trail, a virtual link, or an
internal patchcord.
EID-6266 The card cannot be changed because the port has not been
provisioned.
EID-6267 Each port can have a maximum of 8 MAC addresses.
EID-6268 This server trail does not have a valid start or end.
EID-6269 The maximum number of server trails is 3743.
EID-6270 A unique server trail ID could not be allocated.
EID-6271 The server trail already exists.
EID-6272 The server trail size must not exceed the port bandwidth.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-48
Chapter 4 Error Messages
Description
Refer to the error message text.
Refer to the error message text.
The reversion time is invalid. Enter again.
Enter a value between 0 and 10.
Refer to the error message text.
Refer to the error message text.
Timing reference is not supported by SDH
mode.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The user adds a row without a valid VLAN
database loaded.
The user provisions a double footprint card
in a single slot.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
July 2010