Table of Contents
Advertisement
2.6.88 HIBATVG
Clear the HELLO Alarm
Log into both end nodes with the DCC terminations.
Step 1
On the nodes where the alarm occurred, record the slot and port (from the Slot column and Port column
Step 2
in the Alarms window) that the Hello alarm occurs against. This information helps you determine which
DCC termination is mismatched.
Tip
You can log into another node by going to network view and double-clicking the node.
Step 3
On one node, in node view, click the Provisioning > Network > OSPF tabs.
Step 4
In the DCC OSPF Area ID Table area, locate the alarmed DCC termination by comparing slot and port
numbers to the slot and port number indicated in the alarm on the node.
Step 5
Click the Area ID column cell for the mismatched DCC termination.
Step 6
Change the area ID in the cell to the same ID as its partner DCC termination. (The ONS 15600 SDH
defaults to 0.0.0.0 format addresses.)
Step 7
Click Apply.
Step 8
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447).
2.6.88 HIBATVG
The HIBATVG condition is not used in this platform in this release. It is reserved for development.
2.6.89 HI-LASERBIAS
For information about this condition, refer to the "Alarm Troubleshooting" chapter of the
Cisco ONS 15454 DWDM Troubleshooting Guide.
2.6.90 HI-RXPOWER
For information about this condition, refer to the "Alarm Troubleshooting" chapter of the
Cisco ONS 15454 DWDM Troubleshooting Guide.
2.6.91 HI-TXPOWER
For information about this condition, refer to the "Alarm Troubleshooting" chapter of the
Cisco ONS 15454 DWDM Troubleshooting Guide.
2.6.92 HLDOVRSYNC
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-66
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA) condition
Chapter 2 Alarm Troubleshooting
July 2010
Advertisement
Table of Contents
Troubleshooting
