Cisco ONS 15600 SDH Troubleshooting Manual page 273

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3041 An error occurred while applying changes.
EID-3042 The flow control low value must be less than the flow control
high value for all ports in the card.
EID-3046 The flow control watermark value must be between {0} and
{1}, inclusive.
EID-3047 The file {0} could not be read.
Please verify the name and try again.
EID-3048 There is no Cisco IOS startup configuration file available to
download.
EID-3049 The download cannot be done at this time because an update in
progress.
EID-3050 An error occurred while trying to save the file to your local file
system.
EID-3051 The configuration file has a maximum size of {0} bytes.
EID-3052 An error occurred while saving the configuration file to the
TCC2/TCC2P.
EID-3053 The value of {0} must be between {1} and {2}.
EID-3054 The provisioned input/output ports cannot be removed or
another user is updating the card. Please try to remove these
ports later.
EID-3055 The soak maintenance pane cannot be created.
EID-3056 Defaults cannot be saved to the file {0}.
EID-3057 Default properties cannot be loaded from the node.
EID-3058 The file {0} does not exist.
EID-3059 An error occurred while refreshing.
EID-3060 The ALS recovery pulse interval must be between {0} seconds
and {1} seconds.
EID-3061 The ALS recovery pulse duration must be between {0} seconds
and {1} seconds.
EID-3062 An error occurred while setting values in the table.
EID-3064 This is not a G1000 card.
July 2010
Description
CTC is unable to create a protection group.
Check if the protect port supports circuits, a
timing reference, SONET RS-DCC,
orderwire, or a test access point.
Refer to the error message text.
The flow control watermark value must be
between the two specified values.
Refer to the error message text.
CTC could not find the configuration file
for Cisco IOS startup.
Refer to the error message text.
Check whether the file already exists and
cannot be over written, or there is a space
constraint in the file system.
The size of the configuration file should not
exceed the specified number of bytes.
Refer to the error message text.
The value of the item must be between the
specified values.
Another user may be updating the card. You
can try again later.
Refer to the error message text.
CTC cannot save the defaults to the
specified file.
Refer to the error message text.
Refer to the error message text.
There was an error while refreshing.
The automatic laser shutdown (ALS)
Recovery Interval must be between the
specified range of seconds.
The ALS Recovery Duration must be
between the specified range of seconds.
Refer to the error message text.
This card is not a G1000-4 card.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-17