Eqpt (Pim); Clear The Eqpt (Pim) Alarm; Eqpt (Ppm); Clear The Eqpt (Ppm) Alarm - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 2 Alarm Troubleshooting
Removing a card that currently carries traffic on one or more ports can cause a traffic hit. To avoid this,
Caution
perform an external switch if a switch has not already occurred. See the
Lock Initiation, and Clearing" section on page 2-123
When you replace a card with the identical type of card, you do not need to make any changes to the
Note
database.
If the alarm does not clear, log onto http://www.cisco.com/techsupport for more information or call
Step 5
Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.

2.6.45 EQPT (PIM)

The EQPT alarm for the ASAP card 4PIO module (or PIM) is raised when all ports on the four-port
module fail.

Clear the EQPT (PIM) Alarm

Step 1 Complete the
Step 2 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447) to report a Service-Affecting (SA) problem.

2.6.46 EQPT (PPM)

The EQPT alarm for the SFP (PPM) is raised when one of the SFP (PPM) ports on a four-port 4PIO
(PIM) module fails.

Clear the EQPT (PPM) Alarm

Replace the alarmed SFP (PPM) by completing the
Step 1
on page
If the alarm does not clear, move traffic off any active PPMs (SFPs). See the
Step 2
Port Force Switch Command" procedure on page
using the instructions in the "Install Cards and Fiber-Optic Cable" chapter in the Cisco ONS 15600 SDH
Procedure Guide.
July 2010
Default Severity: Critical (CR), Service-Affecting (SA) (SA
Logical Object: PIM
"Replace an ASAP 4PIO (PIM) Module" procedure on page
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: PPM
2-138.
"2.8.2 Protection Switching,
for more information.
2-138.
"Replace an ASAP SFP (PPM) Module" procedure
2-123. After switching traffic, replace the 4PIO (PIM)
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2.6.45 EQPT (PIM)
"Initiate a 1+1 Protection
2-45