Cisco ONS 15600 SDH Troubleshooting Manual page 287

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3383 The GFP buffers available must be between {0} and {1} and
may be increased in increments of {2}.
WID-3384 You are about to force the use of Secure Mode for this chassis.
You will not be able to undo this operation.
Is it OK to continue?
EID-3385 {0}. Delete the circuits and try again.
EID-3386 The transponder mode could not be provisioned:
{0}
EID-3387 You must change port(s) {0} to an out-of-service state before
changing card parameters. Click "Reset" to revert the changes.
EID-3388 The card mode cannot be changed because the card has circuits. Refer to the error message text.
EID-3389 An error occurred while changing the card mode.
EID-3390 The port is in use.
EID-3391 The port rate cannot be changed because the port has been
deleted.
WID-3392 The timing reference(s) could not be assigned because with
external timing, only a single protected, or two unprotected
timing references per BITS Out can be selected.
Please use the "Reset" button and verify the settings.
WID-3393 The timing reference(s) could not be assigned because with line
or mixed timing, only a single unprotected timing reference per
BITS Out can be selected.
Please use the "Reset" button and verify the settings.
EID-3394 An error occurred while refreshing the power monitoring
values.
EID-3395 The configuration is invalid.
{0}
EID-3396 The configuration is invalid. The standby controller card is not
a TCC2P card.
EID-3397 The file {0} is the wrong version.
EID-3398 The PPM cannot be deleted.
EID-3399 The PPM cannot be deleted because it has port(s) in use.
EID-3400 Unable to switch. A force to the primary facility is not allowed. Refer to the error message text.
EID-3401 {0} cannot be provisioned for the port while {1} is enabled.
July 2010
Description
The GFP buffers must be in the specified
range. This can incremented by the
specified value.
Refer to the warning message text.
Refer to the error message text.
The specified transponder mode canot be
provisioned.
All the card ports should be changed to
out-of-service before changing the
parameters.
Refer to the error message text.
Refer to the error message text.
You cannot change the port rate of a card
that has been deleted.
Refer to the warning message text.
Refer to the warning message text.
Refer to the error message text.
CTC encountered an error in IP address, net
mask length, or default router, or a
restricted IIOP port was selected.
The standby controller card should be a
TCC2P card.
The specified file is of wrong version.
Refer to the error message text.
Remove the ports coonected to the
Pluggable Port Module before it can be
deleted.
The relationship between parameters {0}
and {1} are such that enabling either one,
prevents the provisioning of the other.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-31