Cisco ONS 15600 SDH Troubleshooting Manual page 281

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3242 An {1} exists on the selected ports.
Therefore, you must create the {0}s one by one.
WID-3243 The port you have chosen as an {0} endpoint already supports
an {1}. The port cannot support both DCCs. After the {0} is
created, verify that no EOC alarms are present and then delete
the {1} to complete the downgrade.
EID-3244 An {0} exists on the selected ports.
Therefore, you must create the {1}s one by one.
WID-3245 The port you have chosen as an {1} endpoint already supports
an {0}. The port cannot support both DCCs. After the {1} is
created, verify that no EOC alarms are present and then delete
the {0} to complete the upgrade.
EID-3246 The wizard was not able to validate the data.
{0}
EID-3247 An ordering error occurred. The absolute value should be {0}. The absolute value entered was wrong.
EID-3248 The value for the parameter {0} is invalid.
EID-3249 The voltage increment value is invalid.
EID-3250 The power monitor range is invalid.
EID-3251 The requested action could not be completed.
{0}
EID-3252 No download has been initiated from this CTC session.
EID-3253 The reboot operation failed. {0}
EID-3254 An error occurred during validation. {0}
EID-3255 You cannot change the timing configuration because a
Manual/Force operation is in effect.
WID-3256 The timing reference(s) could not be assigned because one or
more of the timing reference(s):
- is already used and/or
- has been selected twice and/or
- is attempting to use the same slot twice.
Please verify the settings.
EID-3257 Duplicate DCC numbers are not permitted. {0}.
EID-3258 A software error occurred while attempting to download the
file.
Please try again later.
July 2010
Description
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The same port can not be used by multiple
DCCs.
The specified DCC already exists on the
selected port. You can create a DCC of
another type.
The port selected as a DCC endpoint
already supports another DCC. Refer to the
warning message text.
CTC encountered an error.
CTC changed the incorrect parameter.
Refer to the error message text.
Refer to the error message text.
CTC could not complete the specified
action.
Refer to the error message text.
Refer to the error message text.
The CTC was unable to validate the values
entered by the user, specified by {0}. This
error message is common to several
different provisioning tabs within the CTC.
Refer to the error message text.
Refer to the warning message text.
CTC detected more than one occurene of
the a DCC number. Remove one of them.
Refer to the error message text.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-25