Cisco ONS 15600 SDH Troubleshooting Manual page 279

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3174 The description ''{0}'' cannot exceed {1} characters.
EID-3175 The operator identifier ''{0}'' cannot exceed {1} characters.
EID-3176 The operator specific information ''{0}'' cannot exceed {1}
characters.
EID-3177 The node name cannot be empty.
EID-3178 The node name ''{0}'' cannot exceed {1} characters.
EID-3179 The protect card is in use.
EID-3180 The 1+1 protection group does not exist.
EID-3181 The Y-cable protection group does not exist.
EID-3182 The topology element is in use and cannot be deleted as
requested.
EID-3183 An error occurred while deleting the protection group.
EID-3184 No {0} was selected.
EID-3185 This ring has an active protection switch operation and cannot
be deleted at this time.
EID-3186 The node is busy: {0} is {1} and cannot be deleted as requested. The request cannot be completed.
EID-3187 An error occurred while deleting the trap destination.
EID-3188 An error occurred during authentication. The password entered
is invalid.
EID-3189 The sum of the {0} must be between {1} and {2}.
EID-3214 The number of high order circuits for the line could not be
retrieved.
EID-3215 An error occurred while refreshing.
EID-3216 The proxy port is invalid.
EID-3217 The statistics could not be refreshed.
EID-3218 The automatic node setup could not be launched.
EID-3219 The automatic node setup information could not be refreshed.
EID-3220 An error occurred while refreshing row {0}.
EID-3222 The statistics could not be cleared.
July 2010
Description
The specified location exceeds the specified
character limit.
The specified operator identifier exceeds
the specified character limit.
The specified operator specific information
exceeds the specified character limit.
The specified name is empty.
The specified name exceeds the specified
character limit.
Refer to the error message text.
Create a 1+1 protection group.
Refer to the error message text.
You cannot delete the topology element
which is in use.
CTC encountered an error while deleting
the protection group.
You must select an item before completing
this task.
Refer to the error message text.
CTC encountered an error deleting the trap
destination.
The password you entered is invalid. Enter
the password again.
Refer to the error message text.
The number of High Orders (STS/STM) for
the line is not available.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC could not refresh statistics values.
Refer to the error message text.
Failure trying to retrieve automatic node
setup information.
Error refreshing the specified row.
Refer to the error message text.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-23