Cisco ONS 15600 SDH Troubleshooting Manual page 296

Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6029 The next hop of a static route cannot be the same as the
destination of the route or an internal network{0}.
EID-6030 The next hop of a static default route must be the provisioned
default router.
EID-6031 No more static routes can be created.
EID-6032 This static route already exists.
EID-6033 A previous operation is still in progress.
EID-6035 The parent entity does not exist.
EID-6036 The parent PPM entity does not exist.
EID-6037 This equipment type is not supported.
EID-6038 The PPM port is invalid.
EID-6039 The card is part of a regeneration group.
EID-6040 Out of memory.
EID-6041 The port is already present.
EID-6042 The port is used as timing source.
EID-6043 A DCC or GCC is present.
EID-6044 The card or port is part of protection group.
EID-6045 The port has overhead circuit(s).
EID-6046 The ITU-T G.709 configuration is not compatible with the data
rate.
EID-6047 The port cannot be deleted because its service state is
OOS-MA,LPBK&MT.
EID-6048 {0} is {1}.
EID-6049 The card operating mode of {0} is not supported.
EID-6050 Some {0} terminations were not {1}d.
{2}
WID-6051 All {0} terminations were {1}d successfully.
{2}
EID-6052 The authentication key can not be blank.
EID-6053 No more SNMP trap destinations can be created.
EID-6054 {0} is not a valid IP address for an SNMP trap destination.
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
4-40
Chapter 4 Error Messages
Description
Static route must have the default route as
the next hop, and not destination of the
route or internal network.
The default route is selected for networks
that do not have a specific route.
You have reached the maximum number of
static routes.
Refer to the error message text.
Another operation is in progress. You must
try after sometime.
Refer to the error message text.
Create a parent entity for the PPM.
CTC does not support this equipment.
Refer to the error message text.
Select another card.
Refer to the error message text.
Refer to the error message text.
Choose another port because the selected
port is being used as a timing source.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
To delete the port, you must change the port
state to Locked,disabled.
The trunk port is in the wrong state to carry
out the action.
CTC does not support the mode of
operation requested on the card.
Refer to the error message text.
Refer to the warning message text.
Enter an authentication key.
You have reached the maximum number of
SNMP trap destinations.
The IP address specified is not a valid
receiver of SNMP traps.
July 2010