Test And Clear The Ethernet Terminal Loopback Circuit - Cisco ONS 15600 SDH Troubleshooting Manual

Chapter 1 General Troubleshooting
g.
h.
i.
j.
k.
Confirm that the newly created circuit appears on the Circuits tab list as a two-way circuit.
Step 4
Note
Step 5 Create the terminal loopback on the destination port being tested:
a.
b.
c.
d.
e.
f.
Step 6 Complete the

Test and Clear the Ethernet Terminal Loopback Circuit

Step 1 If the test set is not already sending traffic, send test traffic on the loopback circuit.
Step 2 Examine the test traffic being received by the test set. Look for errors or any other signal information
that the test set is capable of indicating.
Step 3 If the test set indicates a good circuit, no further testing is necessary on the loopback circuit. Clear the
terminal loopback state on the port:
a.
b.
c.
d.
e.
f.
Clear the terminal loopback circuit:
Step 4
a.
July 2010
In the Circuit Creation source dialog box, select the same Node, card Slot, Port, and VC where the
test set is connected.
Click Next.
In the Circuit Creation destination dialog box, use the same Node, card Slot, Port, and VC used for
the source dialog box.
Click Next.
In the Circuit Creation circuit routing preferences dialog box, leave all defaults. Click Finish.
It is normal for the "LPBKTERMINAL (GIGE)" condition on page 2-90
loopback setup. The condition clears when you remove the loopback.
In node view, double-click the card that requires the loopback, such as the ASAP card in the source
node.
Click the Maintenance > Ethernet > Loopback > Port tabs.
Select Locked,maintenance from the Admin State column. If multiple ports are available, select
the row appropriate for the desired port.
Select Terminal from the Loopback Type column. If multiple ports are available, select the row
appropriate for the desired port.
Click Apply.
Click Yes in the confirmation dialog box.
"Test and Clear the Ethernet Terminal Loopback Circuit" procedure on page
Double-click the ASAP card in the source node with the terminal loopback.
Click the Maintenance > Ethernet > Loopback > Port tabs.
Select None from the Loopback Type column for the port being tested.
Select the appropriate state (Unlocked; Locked,disabled; Locked,maintenance) in the Admin
State column for the port being tested.
Click Apply.
Click Yes in the confirmation dialog box.
Click the Circuits tab.
1.3.2 Perform a Terminal Loopback on a Source-Node Ethernet Port
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
to appear during a
1-33.
1-33