Aud-Log-Low; Au-Lop; Clear The Au-Lop Alarm - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.11 AUD-LOG-LOW

In the Archive Audit Trail dialog box, navigate to the directory (local or network) where you want to
Step 4
save the file.
Step 5 Enter a name in the File Name field.
You do not have to assign an extension to the file. It is readable in any application that supports text files,
such as WordPad, Microsoft Word (imported), etc.
Step 6 Click Save.
The 640 entries are saved in this file. New entries continue with the next number in the sequence, rather
than starting over.
Step 7 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
for more information or call Cisco TAC (1 800 553-2447).
2.6.11 AUD-LOG-LOW
The Audit Trail Log Low condition occurs when the audit trail log is 80 percent full.
AUD-LOG-LOW is an informational condition. It does not require troubleshooting.
Note

2.6.12 AU-LOP

An AU-LOP alarm indicates that the SDH high order path overhead section of the administration unit
has detected a loss of path. AU-LOP occurs when there is a mismatch between the expected and
provisioned circuit size.
Warning Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of
100 mm could pose an eye hazard. Statement 1056
Warning Use of controls, adjustments, or performing procedures other than those specified could result in
hazardous radiation exposure. Statement 1057

Clear the AU-LOP Alarm

In node view, click the Circuits tab and view the alarmed circuit.
Step 1
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-22
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: NE
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Objects: VCMON-HP
Chapter 2 Alarm Troubleshooting
July 2010