Table of Contents
Advertisement
Chapter 2 Alarm Troubleshooting
2.6.101 IMPROPRMVL (EQPT for the SSXC or TSC Card)
The Improper Removal SSXC, Traffic Card, or TSC card alarm occurs when a TSC card, SSXC card, or
traffic (STM-N) card is physically removed from its slot. This alarm can occur if the card is recognized
by CTC and the active TSC card but is not in service. For example, it could be inserted in the slot but
not fully plugged into the backplane.
If the removed TSC card or SSXC card is the last one on the shelf, the severity is Critical (CR) and traffic
is affected. Otherwise, the alarm is Minor (MN).
Do not remove and reinsert (reseat) a card during a card reboot. If CTC begins to reboot a card before
Caution
you remove the card, allow the card to finish rebooting. After the card reboots, delete the card in CTC
again and physically remove the card before it begins to reboot.
Note
After deleting a card in CTC, the software allows you approximately 15 seconds to physically remove
the card before CTC begins a card reboot.
Clear the IMPROPRMVL (SSXC, TSC) Alarm
Complete the
Step 1
SSXC. (The procedure is similar for both.)
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 2
for more information or call Cisco TAC (1 800 553-2447).
2.6.102 IMPROPRMVL (FAN)
The Improper Removal Fan alarm occurs when Fan Tray 1, 2, or 3 is physically removed from its slot.
Clear the IMPROPRMVL (FAN) Alarm
Step 1
Refer to the "Maintain the Node" chapter in the Cisco ONS 15600 SDH Procedure Guide for procedures
to replace the fan-tray assembly.
Always use the supplied electrostatic discharge wristband when working with a powered
Caution
ONS 15600 SDH. Plug the wristband cable into the ESD jack located on the lower-right edge of the shelf
assembly.
July 2010
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
"Reset a Card with a Card Pull (Reseat)" procedure on page 2-133
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: FAN
2.6.101 IMPROPRMVL (EQPT for the SSXC or TSC Card)
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
for the TSC card or
2-73
Advertisement
Table of Contents
Troubleshooting
