Eqpt (Cap); Eqpt (Eqpt); Clear The Eqpt Alarm - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.43 EQPT (CAP)

Recreate the RS-DCC termination. Refer to the "Turn Up Network" chapter in the
Step 12
Cisco ONS 15600 SDH Procedure Guide for instructions.
Step 13 Verify that both ends of the DCC have been recreated at the optical ports.
If the alarm has not cleared, call Cisco TAC (1 800 553-2447). If the Cisco TAC technician tells you to
Step 14
reseat the card, complete the
Cisco TAC technician tells you to remove the card and reinstall a new one, follow the
Card" procedure on page
2.6.43 EQPT (CAP)
An Equipment Failure alarm for the CAP indicates that the customer access panel has a physical failure.
Log into the Technical Support Website at http://www.cisco.com/techsupport for more information or
call Cisco TAC (1 800 553-2447).

2.6.44 EQPT (EQPT)

An Equipment Failure alarm indicates that a hardware failure has occurred on the reporting card. If the
EQPT alarm occurs with a BKUPMEMP alarm, refer to the
page
This alarm is also invoked if a diagnostic circuit detects a card application-specific integrated circuit
(ASIC) failure. In this case, if the card is part of a protection group, an APS switch occurs. If the card is
the protect card, switching is inhibited. The standby path generates a path-type alarm.

Clear the EQPT Alarm

Complete the appropriate procedure in the
Step 1
page 2-130
Verify that the reset is complete and error-free and that no new related alarms appear in CTC. For LED
Step 2
appearance, see the
If the CTC reset does not clear the alarm, complete the appropriate procedure in the
Step 3
Card Reseating, Resetting, and Replacement" section on page 2-133
card.
Caution Always use the supplied electrostatic discharge wristband when working with a powered
ONS 15600 SDH. Plug the wristband cable into the ESD jack located on the lower-right edge of the shelf
assembly.
If the physical reseat of the card fails to clear the alarm, complete the
Step 4
page 2-134
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-44
"Reset a Card with a Card Pull (Reseat)" procedure on page
2-136.
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: CAP
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
2-26. The BKUPMEMP procedure also clears the EQPT alarm.
section.
"2.7 LED Behavior" section on page
procedure for the reporting card.
"2.6.19 BKUPMEMP" section on
"2.8.3 CTC Card Resetting and Switching" section on
2-120.
section procedure for the reporting
Chapter 2 Alarm Troubleshooting
2-133. If the
"Replace a TSC
"2.8.4 Physical
"Replace an I/O Card" section on
July 2010