Table of Contents
Advertisement
Table 4-3: Rates (Modulation Schemes and Coding)
No.
Rate
1
BPSK 1/2
2
BPSK 3/4
3
QPSK 1/2
4
QPSK 3/4
5
QAM16 1/2
6
QAM 16 3/4
7
QAM 64 2/3
8
QAM 64 3/4
Show
Select this option to view the current values/options of the Multirate
algorithm parameters.
Update
Select this option to update any of the Multirate parameters. The
Multirate parameters are:
Multirate Enable/Disable
The Multirate Enable/Disable parameter controls whether the multirate
algorithm should be used to determine current optimal rates in both the
uplinks and the downlinks.
The default is Enable
NOTE
The multirate algorithm should always be enabled. The option to disable it is available to
enable using a fixed rate to support certain tests. After each reset the AU/µBST boots
with the multirate enabled, disregarding its status before the device was reset.
Uplink Basic Rate
The Basic Rate for all uplinks.
The available options are listed in Table 4-3 on page 4-41.
The default rate is the lowest rate BPSK 1/2 (rate 1).
Manual Revision 1.0
AU Menu
4-41
Advertisement
Table of Contents
