Description - Honeywell GNS-XLS Operator's Manual

AFIS DMU P/N 400-045500-0130 WITH MOD 1

DESCRIPTION

This section discusses additional features in the AFIS system intend-
ed for regional airline use. This discussion begins at the INITIALIZE
Page . The information in
MENU Page also applies to this section.
INITIALIZE PAGE
This page appears when the
AFIS Key is first pressed after
power-up. This page allows
the operator to enter and trans-
mit flight information to initialize
the flight at the home base. All
information must be entered
before subsequent pages can
be accessed. See Figure 8-44.
This page can also be
accessed from the AFIS MENU
Page in order to change data.
20:09: UTC hours and min-
utes. Four digits can be entered if the time is not available from the
navigational system or the data link.
FLT#: This four digit field is used for entering the flight number.
DEPT: A four character field is used for entering the departure air-
port identifier.
DEST: This four character field is used to enter the destination air-
port identifier.
ETD: Estimated time of departure. Enter one or two digits for hours
and two digits for minutes.
ETE: Estimated time in route. Enter one digit for hours and two dig-
its for minutes.
CA: Enter up to five characters for captain identification.
FO: Enter up to five characters for first officer identification.
FA: Enter up to five characters for flight attendant identification.
ACM: Enter up to five characters to identify additional crew member.
Rev 8
GNS-X
Apr/00
Section 7 discussed prior to the AFIS
20:09
FLT# 1290
<
DEPT KIXD
DEST KLAX
<
ETD
ETE
<
<
FMS with Regional Airline AFIS
LS
INITIALIZE
CA
FO
FA
2045 ACM
3+30
TRANSMIT
Figure 8-44
>
>
>
>
>
8-35