FLIGHT PLAN (FPL) SELECTION
This procedure is used to transfer a stored FPL to active FPL status.
It is recommended that the initialization position and the first waypoint
of the Active Flight Plan are the same so that the TO/FROM Leg
Distance displays the correct information. The DIRECT TO function to
the first waypoint on the flight plan may also be used to insure dis-
If a stored flight plan is currently displayed, proceed to Step 5.
FPL Key - DEPRESS (if required) until the desired FLIGHT
PLAN LIST Page appears.
NOTE: If the desired Flight Plan is not listed refer to the procedure for
Creating a Flight Plan. Page 3-6
Line Select Key - DEPRESS to position the cursor over the
desired Flight Plan Number.
NOTE: If desired Flight Plan number is known, position the cursor on
the page, enter the number and depress ENTER Key. The desired
Flight Plan will be displayed.
ENTER Key - DEPRESS.
FLIGHT PLAN Page - VERIFY Flight Plan. Review routing by
depressing PRV or NXT Key to page through multiple Flight Plan
NOTE: DEPRESS FPL or NXT Key to sequence to an alternate Flight
Plan with the same departure destination pair and higher Flight Plan
DEPRESS PRV or BACK Key to sequence to a lower Flight Plan num-
ber with the same departure-destination pair.
Line Select Key- DE-
PRESS to position cursor
over SELECT? (Figure 3-
a. to transfer the Stored
Flight Plan to Active
Flight Plan status con-
tinue with Step 6.
Flight Management System