Reviewing, Editing, Or Canceling A Holding Pattern; Reviewing - Honeywell GNS-XLS Operator's Manual

Selecting Exit Mode:
10. Line Select Key - DE-
PRESS to position the
cursor over MANUAL or
AUTO. Press the BACK
key to change exit mode
option. Selecting MANU-
AL will initiate a continu-
ous hold.
AUTO will exit the hold
the next time the HP fix is
crossed or after the entry
procedure is completed.
(Figure 3-109)
11. ENTER Key - DEPRESS. OK? ENTER prompt will appear. Verify
inputs.
12. ENTER Key - DEPRESS to load the Holding Pattern at the selected
waypoint and return to the NAVIGATION, DIRECT TO, or FPL
Page.

REVIEWING, EDITING, OR CANCELING A HOLDING PATTERN

This procedure enables the pilot to review, edit, or cancel a Holding
Pattern at a specific waypoint.

REVIEWING

1. NAV, FPL, or
2. Line Select Key - DEPRESS to position the cursor over desired HP
waypoint.
NOTE: On NAVIGATION Pages, only the TO Waypoint can be select-
ed, and on the Active Flight
Plan, the TO Waypoint can
only be reviewed.
3. HOLD Key - DEPRESS
to display HOLDING
PATTERN Page. (Figure
3-110)
4. Holding Pattern - REVIEW.
Rev. 3
Sep/96
Selecting
d
Key - DEPRESS to display applicable page.
GNS-X Flight Management System
LS
System Operation
HOLDING PATTERN
AT TRM (USA)
DIRECT ENTRY
INBOUND CRS
MAX HOLDING TAS
TURN DIR
LEG TIME
LEG DIS
EXIT MODE
OK? ENTER
Figure 3-109
HOLDING PATTERN
AT TRM (USA)
DIRECT ENTRY
INBOUND CRS
MAX HOLDING TAS
TURN DIR
LEG TIME
LEG DIS
EXIT MODE
OK? ENTER
Figure 3-110
1/1
>
013
259
>
RIGHT
1.0
>
(3.2)
MANUAL
>
1/1
>
013
>
RIGHT
1.0
>
(3.2)
MANUAL
>
CANCEL
3-65