Returning To Auto - Honeywell GNS-XLS Operator's Manual

RETURNING TO AUTO

1. AFIS Key - DEPRESS to
display AFIS MENU Page.
2. Line Select
DEPRESS to position cur-
sor over Option 8, OPER-
ATING MODES. (Figure 7-
122)
3. ENTER Key - DEPRESS.
4. Line Select
DEPRESS to position cur-
sor over MAN or OFF
option of ground network
field. (Figure 7-123)
5. BACK Key - DEPRESS
until AUTO appears in the
cursor. (Figure 7-124)
6. ENTER Key - DEPRESS to
select AUTO mode.
NOTE: AUTO REPORT,
AUTO WX UPDT, and OPER-
ATING MODE selection status
are stored in non-volatile memo-
ry. If the operator turns to OFF
or MAN, the operator must res-
elect to turn ON.
The ACTIVE LINK information
at the bottom of the page indi-
cates the network that is being
serviced at that time. If the
system is operating in automatic
mode and the network selected
by the present position informa-
tion is turned OFF or none are
operational, NONE will be dis-
played.
Rev. 5
GNS-X
Sep/97
Key -
Key -
Flight Management System AFIS Operation
LS
AFIS MENU
1 AFIS FLT PLAN
<
2 SIGMETS
3 TERMINAL WX
<
4 WINDS ALOFT
5 RECALL AFIS FPL
<
6 SEND AFIS MSG
7 DISPL AFIS MSG
<
8 OPERATING MODES
Figure 7-122
AFIS OPERATING MODES
AUTO REPORT
AUTO WX UPDT
ARINC
SITA/AVICOM
AIR CANADA
ACTIVE LINK:
Figure 7-123
AFIS OPERATING MODES
AUTO REPORT
AUTO WX UPDT
ARINC
SITA/AVICOM
AIR CANADA
ACTIVE LINK:
Figure 7-124
>
ON
ON
>
OFF
OFF
>
OFF
NONE
>
ON
ON
>
AUTO
OFF
>
OFF
ARINC
7-59