Departure Page - Honeywell GNS-XLS Operator's Manual

APPROACH:
Used to access the APPROACH Page to enter a non-precision
approach. (Figure
XFILL: Used to transfer information between systems in a dual sys-
tem installation. In a single system installation, this prompt will not be
displayed.
SELECT or INVERT:
Used to transfer a Stored Flight Plan to the ACTIVE FLIGHT PLAN
Page. Depressing the BACK Key when the cursor is over this field
brings up INVERT?, which is used to transfer the waypoint of a
Stored Flight Plan to the ACTIVE FLIGHT PLAN Page in reverse
order. (Figure 2-5)
ERASE:
Used to clear an entire flight plan.

DEPARTURE Page

Accessed by pressing the Line Select Key adjacent to DEPART on
the FLIGHT PLAN Page. With the cursor over DEPART press
ENTER.
NOTE: Each field will prefill if there is only one choice for that partic-
ular field or DEPARTURE airport field will flash if no Departure is
available. A NO SIDS AVAILABLE message will appear at the bot-
tom of the screen.
DEPARTURE:
Departure airport identifier. This field prefills if first waypoint on the
flight plan is an airport or runway, or it can be manually entered.
(Figure 2-6)
RUNWAY:
Departing runway. This field
prefills if first waypoint on the
flight plan is a runway, or it
can be selected from a list
made available by pressing
the Line Select Key adjacent
to the RUNWAY field.
(Figure 2-6)
Rev. 3
Sep/96
2-5)
(Figure
<
<
GNS-X Flight Management System
LS
Page Display Definitions
2-5)
DEPARTURE KLAX
RUNWAY
SID
TRANSITION
RW06L
RW06R
RW07L
RW07R
'
Figure 2-6
1/1
<
------
------
<
------
erase
2-5