Entering A Sid On The Active Fpl - Honeywell GNS-XLS Operator's Manual

System Operation
Due to the way the GNS-X
have unique identifiers. However, some duplicate identifiers exist for
more than one waypoint location. These waypoints are primarily
located on APPROACHES, SIDS and STARS. In these cases the
waypoint identifiers are renamed in the database as a 6 character
identifier. Two naming conventions are used, one for four character
identifiers and one for five character identifiers.
Four character waypoints have the first four characters but add the
last two characters of the ICAO airport identifier as shown in the fol-
lowing example:
MA11 at KPRC becomes MA11RC in the database.
Five character waypoints have the first five characters but add the
last character of the ICAO airport identifier as shown in the following
example:
MA27L at KOAK becomes MA27LK in the database.

ENTERING A SID ON THE ACTIVE FPL

NOTE: These procedures may also be used with a stored flight plan.
1. FPL Key - DEPRESS to display Active FPL Page.
2. Line Select Key - DE-
PRESS to position cur-
sor over the DEPART?
field (Figure 3-22).
3. ENTER Key - DEPRESS
to display DEPARTURE
Page.
4. DEPARTURE Airport
Identifier - VERIFY or
INSERT valid ident.
NOTE: If the first waypoint on the Flight Plan is an airport, the
Departure ident prefills and the cursor is positioned over the first SID
identifier on the list.
If the first waypoint on the Flight Plan is a runway, the RUNWAY field
also prefills and the cursor is over the first SID identifier on the list.
3-18
database is structured, waypoints must
LS
<
<
<
<
GNS-X Flight Management System
LS
ACTIVE FPL
FR KSEA - KLAX
TO KLAX
*****
DEPART ?
ARRIVE
APPROACH
Figure 3-22
1/1
ETE
>
ERASE
Rev. 3
Sep/96