Remove And Replace The Integrator Rod Assembly; Remove And Replace The Fold Mirror - Christie J series 2.0kW Service Manual

4.5.25 Remove and Replace the Integrator Rod Assembly

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
2. Remove the lens side cover:
a. Loosen the 6 quick-release screws.
b. Remove the cover and set it aside.
3. Remove the screw securing the contrast aperture cover.
4. Remove the three screws securing the panel.
5. Remove the 4 screws securing the integrator cover.
6. Unscrew the integrator adjustment knob.
7. Remove the integrator rod assembly. NOTE: Do not touch the glass surface.
8. Replace the integrator rod assembly:
a. Clean the integrator rod with compressed air.
b. Lower the integrator into the optics tray with the polished end toward the lamp compartment.
c. Place the spring clip and standoff over the threaded shaft.
d. Install the integrator rod adjustment knob.
e. Clean the integrator rod with compressed air.
f. Replace the optics cover, the contrast aperture and light tube panel.
9. Adjustment of the

4.5.26 Remove and Replace the Fold Mirror

1. Power down the projector:
a. Turn the projector off and allow the projector to cool for a minimum of 5 minutes.
b. Disconnect the AC power cord from the rear of the projector.
2. Remove the lens side cover:
a. Loosen the 6 quick-release screws.
b. Remove the cover and set it aside.
J Series 2.0, 2.4, and 3.0kW Service Manual
020-100739-01 Rev. 1 (01-2012)
Fold Mirror Adjustment
Section 4: Parts and Module Replacement
and Integrator Assembly Adjustment may be required.
4-31