Verify The Dimm - Oracle SPARC T5-8 Service Manual

Verify the DIMM

Verify the DIMM
1. Ensure that you have completed the following:
Applied power to the server.
■
See
■ Started the system.
See
Log in to Oracle ILOM.
2.
See "Log In to Oracle ILOM (Service)" on page
3.
Start the faultmgmt shell.
start SP/faultmgmt/shell
->
Are you sure you want to start the faultmgmt shell (y/n)?
faultmgmtsp>
4.
Use the fmadm faulty command to determine if the server is operating normally.
If a fault was detected, the server is not operating normally.
■
See
If no fault was detected, the DIMM was installed successfully.
■
Related Information
"DIMM Configuration" on page 71
■
"DIMM Configuration Fault Messages" on page 76
■
"Install a DIMM" on page 78
■
80 SPARC T5-8 Server Service Manual • November 2015
"Connect the Power Cords" on page
"Power On the Server (Oracle ILOM)" on page
"Diagnostics Process" on page
191.
192.
28.
y
25.