Remove The Service Processor Card - Oracle SPARC T5-8 Service Manual

Remove the Service Processor Card

System Service Required LEDs on the front panel and rear I/O module
■
Server SP LED on the main module and rear I/O module
■
Determine if the System Service Required LED is lit on the front panel or the rear
1.
I/O module.
See "Interpreting LEDs" on page
2. Check the SP LED on the main module or the rear I/O module.
See "Front Panel Controls and LEDs" on page 31
LEDs" on page
replaced.
Remove the faulty service processor card.
3.
See "Remove the Service Processor Card" on page
Related Information
"Remove the Service Processor Card" on page 110
■
"Install the Service Processor Card" on page 112
■
"Verify the Service Processor Card" on page 114
■
Remove the Service Processor Card
The service processor card is a cold-service component that can be replaced only after you have
removed the main module.
Caution -
discharge. This discharge can cause server components to fail.
1. Determine your first step:
a. If you cannot access the service processor card, go to
b. If you can access the service processor card, back up the SP configuration
information.
->
->
where:
The acceptable values for uri are tftp, ftp, sftp, scp, http,and https.
■
110 SPARC T5-8 Server Service Manual • November 2015
33. The SP LED will be lit amber if the service processor card needs to be
This procedure requires that you handle components that are sensitive to electrostatic
cd /SP/config
dump -destination uri target
29.
or "Rear Panel Controls and
110.
Step 2.