Oracle SPARC T5-8 Service Manual page 87

This command helps you identify the drive you installed. Example:
Ap_id
...
c2
c2::w5000cca00a76d1f5,0
c3
c3::sd2
c4
c4::w5000cca00a59b0a9,0
...
4.
Configure the drive using the cfgadm -c configure command.
Example:
# cfgadm -c configure c2::w5000cca00a76d1f5,0
Replace c2::w5000cca00a76d1f5,0 with the drive name for your configuration.
5. Verify that the blue Ready to Remove LED is no longer lit on the drive that you
installed.
6.
At the Oracle Solaris prompt, type the cfgadm -al command to list all drives in the
device tree, including any drives that are not configured:
cfgadm -al
#
The replacement drive is now listed as configured. Example:
Ap_id
...
c2
c2::w5000cca00a76d1f5,0
c3
c3::w5000cca00a772bd1,0
c4
c4::w5000cca00a59b0a9,0
...
7. Perform one of the following tasks based on your verification results:
If the previous steps did not verify the drive, see
■
Process" on page
If the previous steps indicate that the drive is functioning properly, perform
■
the tasks required to configure the drive. These tasks are covered in the
Oracle Solaris OS administration documentation.
For additional drive verification, you can run the Oracle VTS software. Refer to the Oracle VTS
documentation for details.
Type Receptacle
scsi-sas connected
disk-path connected
scsi-sas connected
disk-path connected
scsi-sas connected
disk-path connected
Type Receptacle
scsi-sas connected
disk-path connected
scsi-sas connected
disk-path connected
scsi-sas connected
disk-path connected
25.
Verify the Hard Drive
Occupant Condition
configured unknown
configured unknown
configured unknown
unconfigured unknown
configured unknown
configured unknown
Occupant Condition
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
configured unknown
"Diagnostics
Servicing Hard Drives 87