Oracle SPARC T5-8 Service Manual page 170

Install a Card Carrier
Rotate the handle up until it latches into place.
Reconnect all of the cables and any transceivers, if applicable, to the PCIe card.
4.
5. Determine your next step:
If you replaced or installed a PCIe card in a server that is running (if you hot-swapped the
■
card), go to
If you replaced or installed a PCIe card in a powered-down server, power on the server
■
using the instructions provided in
6. Use one of the following methods to bring the PCIe card online:
a. Press the Attention button.
The card's Power OK LED should illuminate, indicating that the card is online.
b. At the Oracle Solaris prompt, power on and enable the PCIe card.
Example:
#
#
7. Verify the card's installation.
See "Verify the PCIe Card" on page
170 SPARC T5-8 Server Service Manual • November 2015
Step 6.
hotplug poweron /pci@340/pci@1/pci@0/pci@6 PCIE3
hotplug enable /pci@340/pci@1/pci@0/pci@6 PCIE3
"Returning the Server to
171.
Operation", then go to Step 7.