Run Post With Maximum Testing - Oracle SPARC T5-8 Service Manual

Run POST With Maximum Testing

Commands:
->
Related Information
"POST Overview" on page 35
■
"Oracle ILOM Properties That Affect POST Behavior" on page 35
■
"Run POST With Maximum Testing" on page 40
■
Oracle ILOM Documentation Library
■
Run POST With Maximum Testing
This procedure describes how to configure the server to run the maximum level of POST.
Log in to Oracle ILOM.
1.
See "Log In to Oracle ILOM (Service)" on page
2.
Set the virtual keyswitch to diag so that POST runs in service mode.
Alternatively, you can use the /System target.
set /HOST keyswitch_state=diag
->
Set 'keyswitch_state' to 'Diag'
3. Run POST.
Alternatively, you can use the /System target.
start /SYS
->
Are you sure you want to start /SYS (y/n)?
Starting /SYS
4. Start the system console to view the output of the tests.
start /HOST/console
->
Related Information
"POST Overview" on page 35
■
"Oracle ILOM Properties That Affect POST Behavior" on page 35
■
"Configure POST" on page 39
■
Oracle ILOM Documentation Library
■
40 SPARC T5-8 Server Service Manual • November 2015
cd
set
show
28.
y