Configure Voice-Port Cptone; Configure Voice-Port Signal - Avaya 2330 Reference Manual

Example
AG/configure/voice-port (7/2/1)# no battery-reversal

configure voice-port cptone

Use this command to specify a regional analog voice-interface-related tone, ring, and cadence
setting for an FXS or FXO voice port.
By default, regional tone is set to USA.
Syntax
[no] cptone {us | ca}
Table 402: Variable definitions
us
ca
[no]
Example
AG/configure/voice-port (7/2/1)# cptone us

configure voice-port signal

Use this command to specify loop-start or ground-start signaling for an FXS or FXO voice
port.
By default, the FXS and FXO ports are configured for loop-start signaling.
Syntax
[no] signal {loop-start | ground-start }
Table 403: Variable definitions
loop-start
ground-start
Command Line Reference
Variable
Variable
Value
Sets the region tone to USA.
Sets the region tone to Canada.
Sets the region tone value to the default:
us.
Value
Specifies the use of loop start signaling.
Specifies the use of ground start signaling.
configure voice-port cptone
August 2013 365