Vlan Classification Protocol Rule; Switchport Mode Access Vlan-Stacking - Avaya 2330 Reference Manual

Syntax
[no] vlan classification ipv4
Example
AG/configure/interface/ethernet (6/1)# vlan classification ipv4

vlan classification protocol rule

After you have defined protocol rules, you can apply those rules to an interface. Use this
command to apply a protocol-based classification rule to an interface.
Important:
You can apply VLAN classification rules only on hybrid ports.
Syntax
[no] vlan classification protocol rule <id> vlan <vid>
Table 90: Variable definitions
<id>
[no]
<vid>
Example
AG/configure/interface/ethernet (6/1)# vlan classification protocol
rule 1 vlan 4

switchport mode access vlan-stacking

Use this command to enable VLAN stacking on an interface.
Note that the no command option is unavailable for VLAN stacking. To disable VLAN stacking,
enter switchport mode access for the interface.
Syntax
switchport mode access vlan-stacking
Command Line Reference
Variable Value
Specifies the VLAN classifier rule ID. Valid
values are 1 to 12.
Removes a protocol-based VLAN
classification rule from the interface.
Specifies the VLAN ID.
vlan classification protocol rule
August 2013 111