Configure Terminal Voice Service Voip Ssm Bind Ip; Configure Terminal Voice Service Voip Ssm Bind Transport - Avaya 2330 Reference Manual

Example
AG/configure#system logging syslog module voip-ssm-cdr sys9 warn

configure terminal voice service voip ssm bind ip

Use this command to bind the IP address for SSM. This IP address needs to be validated
against an existing IP interface address. Signaling and media uses this address as a source
address. The application listens to this address for SIP signaling.
The configuration does not take effect until enable is executed. Before changing or removing
an IP address or shutting down or deleting the interface, you must first disable SSM (ssm
no enable) .
By default, no IP address is configured.
Syntax
[no] bind ip ipv4:<A.B.C.D>
Table 417: Variable definitions
[no]
<A.B.C.D>
Example
AG/configure/voice/service/voip/ssm# bind ip ipv4:10.10.0.1

configure terminal voice service voip ssm bind transport

Use this command to configure the transport protocol and port on which the SSM accepts SIP
requests. By default, SSM listens on both the transport protocols: UDP and TCP. Use the bind
transport command to limit it to either UDP or TCP. Each port is validated against an existing
port used in the local SIP IP port. If the two ports are the same and have the same IP, a warning
message is displayed requesting you to reconfigure the SIP IP port.
Command Line Reference
Variable
Variable
configure terminal voice service voip ssm bind ip
Value
• info: informational and above
• debug: all messages
• none: no messages
Value
Removes the specified IP address
binding.
Specifies the IP address to bind for SSM.
August 2013 379