Configure Sla Profile Udp-V6-Jitter - Avaya 2330 Reference Manual

Example
AG/configure/sla/profile 1# udp-v6-echo 2001::3

configure sla profile udp-v6-jitter

To calculate two-way/one-way delay/jitter for UDPv6 packets, use this command to configure
the IPv6 address of destination and other related parameters.
Syntax
[no] udp-v6-jitter <operation> <ipv6-addr> [port <port>] [packet-
spacing <value>] [packet-size <value>] [packet-count <value>]
[periodicity <value>] [tc <value>] [hop-limit <value>] [flow-label
<value>]
Table 284: Variable definitions
<operation>
<ipv6-addr>
[port <port>]
[packet-spacing <value>]
[packet-size <value>]
[packet-count <value>]
[periodicity <value>]
[tc <value>]
[hop-limit <value>]
[flow-label <value>]
[no]
Command Line Reference
Variable
configure sla profile udp-v6-jitter
Value
The type of parameter it has to measure and
monitor. Valid: delay, jitter and packet-loss
IPv6 address of the destination system.
The port to which the packets have to be
sent. Valid: 7 or 50002. Default: 50002.
Time spacing between two consecutive
packets in mill seconds. Valid: 10 – 5000.
Default: 20
Size of the packet in bytes. Valid: 1 – 1400.
Default: 80
Number of packets to be sent. Valid: 1 – 100.
Default: 20
After every specified periodicity minutes the
sla will be scheduled again. Valid: 10 – 60.
Default: 10
Traffic class of the IPv6 header. Valid: 0 –
255. Default: 0
Hop limit for the IPv6 packet. Valid: 1 – 255.
Default: 64
Flow label for the packet Valid: 0 – 1048575.
Default: 0
Removes all the udp-v6-jitter
configurations.
August 2013 261