Configure Voice-Port Station Number - Avaya 2330 Reference Manual

Example
AG/configure/voice-port (7/2/1)# station name SJ

configure voice-port station number

Use this command to specify the telephone or extension number that is to be sent as caller ID
information. Use this command at the sending FXS voice port or at an FXO port through which
routed caller ID calls pass.
By default, no station number is configured.
This optional command is configured on FXS voice ports that are used to originate on-net calls.
The information entered is displayed by the telephone attached to the FXS port at the far end
of the on-net call.
This command can also be configured on the FXO port of an AG2330 on which caller ID
information is expected to be received from the Central Office (CO), to suit situations in which
a call is placed from the CO, then goes through the FXO interface, and continues to a far-end
FXS port through an on-net call. In this case, if no caller ID information is received from the
CO telephone line, the far-end call recipient receives the information configured on the FXO
port.
This feature applies only to caller ID name display provided by an FXS port connection to a
telephone device. The station name is not passed through telephone trunk connections
supporting ANI calls. ANI supplies calling number identification only and does not support
calling number names.
Syntax
[no] station number <station-number>
Table 377: Variable definitions
<station-number>
[no]
Example
AG/configure/voice-port (7/2/1)# station number 4082164655
Command Line Reference
Variable
configure voice-port station number
Value
Specifies the station number. Must be a
string of 1 to 15 characters.
Removes the configured station number.
August 2013 347