Connecting One Isdn Bri Station To One Isdn Port; Connecting Two Isdn Bri Stations To One Isdn Port - Avaya G450 Install Book

Note:
The MM720 BRI media module cannot be administered to support both BRI
Note:
trunks and BRI stations at the same time. However, the MM720 BRI media
module supports combining both B-channels together to form a 128-kbps
channel. CM 3.1 enables combining B-channels, using BONDing, to form a
higher bandwidth connection.
Finally, if the MM720 BRI media module is administered to support BRI stations, it
cannot be used as a clock synchronization source.

Connecting one ISDN BRI station to one ISDN port

Connect the station via a standard 8-pin BRI cable to one of the ISDN ports on an MM720
media module.

Connecting two ISDN BRI stations to one ISDN port

1. Connect each station to an RJ-45 splitter that provides two RJ-45 4-pair jacks, and one
RJ-45 male connector. See
2. Connect the male connector of the splitter to one of the ISDN ports on an MM720 media
module.
Figure 9: RJ-45 splitter wiring for connecting two ISDN BRI stations to one ISDN port
Figure 10: The MM720 media module
Step 1: Connecting data and voice devices
Figure 9 for the correct wiring for the splitter.
Issue 5 November 2009 45